3DXHobbies.com-New Jersey

PLEASE NOTE: This is the transmitter only with 7 channel receiver. No servos are included.

7C System Specifics

• Software for airplanes and helis
• Mode 1-4 selectable (modes 3 and 4 available through transmitter software)
• Assignable switches/functions
• Large 72 x 32 LCD screen with adjustable contrast

7C System Overview

• 10-model memory
• 6-character model naming
• Digital trims, trim memory, EPA, sub trims and servo reversing on all channels
• Dual or triple rates* (aileron/elevator/rudder) with 3-position switch use
• Exponential (aileron/elevator/rudder/throttle)
• Adjustable throttle cut
• Fail-safe
• Trainer system (cord required)
• Flap switch
• Retract switch
• Variable rate knob (channel 6)
• Tx and Rx NiCds w/dual output charger
• Adjustable stick length and tension
• Software for Mode 1-4 control setups
• Count up/countdown timer

Continuous Channel Shifting
Other 2.4GHz systems hold firm to one or two frequencies, increasing the potential for interference. The frequency of Futaba 2.4GHz FASST shifts every 2 milliseconds, so there are no signal conflicts or interruptions – and no need for a frequency pin!

Dual Antenna Diversity
Futaba 2.4GHz FASST systems seamlessly select the best reception between two receiver antennas, so there's no loss of signal.
R603FF receiver included with 3PM 2.4GHz does not offer Dual Antenna Diversity. Easy-Link
Futaba 2.4GHz FASST system transmitters leave the factory with a unique and permanent ID code. Once linked to the receiver, the code ensures that the receiver will recognize and respond ONLY to that transmitter. The linking process is simple...just push a button on the receiver.

Pre-Vision
2.4GHz FASST scans incoming data and applies sophisticated error correction techniques – resulting in a system that gives you a solid, impenetrable connection with your model.